Introduction to the APH2O

Description 

The APH2O Combination Chlorine and Turbidity Analyzer is a pre-configured, fully assembled, turn-key water analyzer capable of measuring turbidity, free chlorine (or total chlorine), pH, and temperature. The analyzer displays real-time measurements on an easy-to-read LCD display. It includes data-logging, 4-20ma output, and RS-485 Modbus TCP signal. 

The APH2O connects easily to your water source and comes mounted on an easy-to-mount wall panel. The unique bare-gold electrode technology and sensor reservoir allow for maximum resolution and consistency with minimal maintenance and no need for electrode solutions.  

Product Overview / Features of the APH2O Analyzer 

• Membrane-free and Reagent-free technology. 
• The pre-fabricated design allows for easy installation.  
• Strong, lightweight polyethylene panel mount comes with handles. 
• FCL700 three-parameter composite sensor for residual free or total chlorine, pH and temperature in compliance with USEPA 334.0 guidelines. Advanced sensor PCB offers built-in temperature and pH parameter compensation (up to pH 9.0) algorithms. 
• Unique Bare-Gold electrode technology for residual chlorine measurement eliminates membranes and electrode solution replenishment commonly associated with conventional sensors. 
• UT700 Ultra-Low Turbidity Sensor with Unique Flat Surface Distal End in Quartz Glass Plate. EPA 180.1 compliant.  
• WR20 Sensor Flow Reservoir provides sample calming for dissipation of air-bubbles and settling of suspended solids, foam, or other impurities commonly observed in drinking water influent. Allows the highest level of resolution on the market, and greatly extends the maintenance cycle of the sensor while providing a large buffer capacity to mitigate pressure fluctuations. 
• Factory tested under strict quality guidelines. 
• 13-month limited warranty. 6-month sensor warranty. 

Standard Components of the APH20 Analyzer 

• Chlorine/pH/Temperature Sensor, pre-wired. 
• Turbidity Sensor, pre-wired. 
• 7” LCD Digital Touchscreen Display. 
• Self-regulating flow reservoir. 
• Inlet F-440 flow meter with needle valve adjustment. 
• Inlet isolation valve.  
• Inlet and outlet tubing. 
• 110VAC Power cord. (Power requirement: 96-260VAC 50/60 Hz, 200 W) 
• Sturdy polyethylene mounting panel with handles. 
• FRP strut (3) with hardware. 

Optional Components of the APH2O Analyzer 

• Sensor cleaning solution. 
• pH calibration solutions.  
• Turbidity calibration standards.  
• CAL700 Calibration Kit.  
• AP-MA10-CR 10’ Cable Extension Kit (for use with CAL700 Kit) 

Applications 

The APH2O Water Analyzer can be used on most clean water sources. Best results are achieved when pH is below 9 and temperature is between 40 -104F.  

Applications include: 

• Drinking Water / Domestic Water 
• Secondary Water Supply 
• Sanitary Water 
• Decorative Water / Swimming Water 
• Food & Beverage Process Water 
• RO Feedwater 

Ordering Information 

APH2O Analyzer is ordered with part number: APH2O 

Optional:  

• Sensor Cleaning Solution: 90008-988 
• pH Calibration Combo Pack (includes 4, 7, 10 pH solutions): 90008-983 
• Turbidity Calibration Standard – 500 ml 10NTU Solution: 90008-973  
• Turbidity Calibration Standard – 500 ml 20NTU Solution: 90008-974  
• CAL700 Calibration Kit: CAL700 
• AP-MA10-CR 10’ Cable Extension Kit (recommended for use with CAL700 Kit): 90008-854