Industrial
F-1000
Set-Up and Controls
Powering On the F-1000
The F-1000 requires two (2) AAA Batteries to operate properly. Always use all fresh batteries when replacing batteries. Once batteries are installed, the unit is ready.
Display
The F-1000 Flowmeter has a .35” tall 6-digit display. Up to four decimal places. Units of measure and decimal location are pre-programmed at the factory.
TB and RT units with flow totalization include a rest button. Pressing and holding the reset button for 2 seconds will reset the total to zero. If desired, the reset function can be disabled. To do this, you must open the enclosure and move the jumper on the circuit board. (See manual for details.)
The RT unit has a Mode/Reset button. This button will allow the user to toggle between flow rate and totalization.
