Industrial
S6A
Maintenance
General Maintenance
The S6A Chemical Feed requires minimal maintenance. During normal operation, there is no need for regular maintenance.
If the unit has not been in service for an extended period, it is recommended to inspect the fluid path and flush with clean water before using again.
With some chemicals that contain particulate, periodic cleaning and flushing may be required.
The S6A is easily removed via true-union connections on each end of the unit. Be sure to drain fluid from piping before servicing.
Ensure that no chemical is dripped on S6A from leaking piping. Chemical exposure to the outside of the unit may damage display.
Caution: Use care when reinstalling S6A to maintain O-ring gasket integrity. Failure to O-rings properly may void warranty.
Re-Calibration
If the system flow rate changes significantly from initial calibration and Digital Drawdown, then we recommend performing a Digital Drawdown for the new flowrate to maintain optimum accuracy.
FAQs
Frequently Asked Questions
S6A Maintenance
- What if I need to remove the S6A for maintenance or cleaning, but still need to feed chemicals?
The S6A does not require frequent maintenance when used with a strainer on clean chemicals. Occasionally, the unit may need to be removed if debris is present. Removal and cleaning is simple and quick, as the S6A has true-union connection to piping. Suppose the S6A must be removed for a period of time, during which chemical feed is necessary. In that case, we recommend piping in a by-pass section during initial installation or using a filler piece. Contact Blue-White for assistance with filler piece.
Copyright © 2024 Blue-White
